From: "Steven Levine" <ecs-isp@2rosenthals.com>
Message-ID: <69275c9c.8.mr2ice.fgrirsq@earthlink.net>
Date: Wed, 26 Nov 2025 12:01:32 -0800
To: "eCS ISP Mailing List" <ecs-isp@2rosenthals.com>
In-Reply-To: <list-15120015@2rosenthals.com>
Subject: Re: [eCS-ISP] Updating bind (exceptq=z or zz?)

In <list-15120015@2rosenthals.com>, on 11/26/25
   at 11:18 AM, "Massimo S." <ecs-isp@2rosenthals.com> said:

Hi,

>i've added "set EXCEPTQ=Z" in the config.sys
>bind showed again the issue, but i don't find anywhere an excetpq dump

I was not sufficiently clear.  I meant to say that set EXCEPTQ=Z might
give us an exceptq report with some additional info.  I never meant to
imply that this was a sure thing.

The same is true for set EXCEPTQ=ZZ.

BTW, I would not recommend putting either of these in config.sys.  I would
put them in the script that starts bind.  If you put these in config.sys,
you are likely to get hundreds of not very useful exceptq reports.

Steven

-- 
----------------------------------------------------------------------
"Steven Levine" <steve53@earthlink.net>  Warp/DIY/BlueLion etc.
www.scoug.com www.arcanoae.com www.warpcave.com
----------------------------------------------------------------------