On Sat, 20 Dec 2008 17:13:21 +0945 "Paul Smedley" <ecs-t6x@2rosenthals.com>
wrote:
>Hi Gang,
>
>I've had this problem for a while, but have never worried too much about
>it as the T60 is basically just a hack machine for testing things out on
>when I don't want to trash my desktop, but since my monitor died on my
>last night after a power cut, my desktop is useless, so I'm using the
>T60 full time until I can get the monitor repaired.
>
>Anyway, to the problem - the T60 works great in normal use, the only
>problem is if I leave it idle for a while, I come back and find the
>system sitting at a trap dump screen (Trap 0008).
>
>Any suggestions?
>
>Currently running eCS v2 rc6a (although same trap appeared with older
>rc's too). I might try using Panorama in place of Snap and see if that
>helps, other than than I have no clue :(
>
Hi, Paul...
A couple things come to mind:
Power management & GenMAC
Which Win32 driver is in your wrapper directory? I updated some a while
back, but I'd have to look to see if the few I submitted cover the T60 (I
believe they do/did). Try turning off all power mgmt on the system. Check
the BIOS & embedded controller firmware versions against the latest
available from Lenovo.
If you do swap video drivers, remember that the SDD helper driver improves
Panorama performance by several orders of magnitude, & appears to be safe
(by all accounts thusfar, AFAIK).
If a brainstorm hits, I'll follow up ASAP.
G'day!
___
Lewis G Rosenthal
Rosenthal & Rosenthal, LLC
Sent with SnapperMail
terug naar list