On Tue, 01 Sep 2009 20:08:26 -0400 madodel wrote:
>
>
>As you point
>out the install had ACPI disabled but APM enabled. But it booted to the
>WPS. I enabled ACPI in the final install configuration notebook and
>everything is working fine so far.
It turns out I *must* run apm.add or else the battery widget doesn't work. And before I added
apm.add, acpidaemon wasn't in my config.sys (or perhaps I didn't do something right when I ran the
acpi wizard?).
A problem I am having that I haven't figured out yet:
The config.sys hangs with 2 lines output "route not reachable" and after some time 'Press Enter to
continue'. I believe the long wait before "press enter " is the wait for llaecs as noted below.
RUN=C:\MPTN\BIN\CNTRL.EXE <-- then 2 lines on screen for route unreachable
CALL=C:\OS2\CMD.EXE /Q /C C:\MPTN\BIN\MPTSTART.CMD >NUL
RUN=C:\IBMCOM\PROTOCOL\NBTCP.EXE <--- after Enter is pressed to continue
MPTSTART contains 'call llaecs /s /w:30'
I don't usually run dhcp client on my T61 but decided to try it out when I did my last install. I
usually use a static IP. The /W above is to wait for DHCPCD.
I am getting DHCP from a linksys wrt54g I am currently using ethernet (I haven't set up wlan yet).
If I type out the commands for setup.cmd & mptstart.cmd manually after bootup I don't get any
errors so I figure it's a timing issue with not getting an IP soon enough for the config.sys to
process it.
So I am wondering if I can change something to make this work correctly.
?????