On Sat, 5 Sep 2009 18:27:30 +0100 "Gerry Prosser" <ecs-t6x@2rosenthals.com>
wrote:
>I am still having trouble with the lan connection.
>
>On first boot, before configuring the wireless, it did sort of half
>work - that is to say firefox tried to reload the last pages I looked
>at under RC6a and was able to show me some sites (e.g. ubuntu
>how-to's) but not others (e.g. gmail).
>
>But since getting the wireless configured and working, I cannot even
>ping the router if the wireless is disconnected.
>
>PROTOCOL.INI looks good. TCP addresses are static for lan and dhcp for
>wireless.
TCP/IP configuration should npt be present fpr the wireless, only the wired
interface. Could you post your PROTOCOL.INI and SETUP.CMD?
>There are no error messages., and lantran.log says both
>interfaces are up, as does netstat. And WRND32.LOG shows that both
>drivers were loaded.
>
Okay... this is a good start. We probably aren't getting the tables flushed
when switching adapters.
>When I double-click on the widget, the wireless connection is
>disabled, but I don't get the 'address conflict resolution' window
>that used to show in RC6A
>
>Any ideas ?
>
If you manually bring down your wireless interface (from a prompt, e.g.,
ifconfig lan1 down && ifconfig lan1 delete), and bring up your wired
interface (e.g., ifconfig lan0 192.168.1.100), can you ping your wired
interface? If so, set your default gateway (route add...), and see if you
can ping that. If so, we need to check the XWLAN config to ensure that it
is properly bringing up your wired IF when disconnecting the wireless.
>On Thu, Sep 3, 2009 at 6:09 PM, Lewis G
>Rosenthal<ecs-t6x@2rosenthals.com> wrote:
>> Hi, Gerry...
>>
>> ...... Original Message .......
>> On Thu, 3 Sep 2009 16:57:18 +0100 "Gerry Prosser"
<ecs-t6x@2rosenthals.com>
>> wrote:
>>>the RC7 install found both my nics (10/100/1000 and 4965 a/g/n) but
>>>neither work.
>>>
>>>WPA Supplicant says :
>>>
>>>"WPA: Driver used disabled group cipher 0x8 (mask 0x10) - reject
>>>Associated with <mac address>
>>>WPA: Unsupported CCMP Group Cipher key length 32 (32)
>>>RSN: Failed to configure GTK:
>>>
>>>any idea what that is all about ? WPA/WPA2 was one of the few things
>>>in RC6a that worked well for me 8-(
>>>
>> Sounds like mismatched WPA types. Are you using WPA or WPA2? How is your
AP
>> configured (i.e., TKIP, AES, or TKIP+AES - the latter gives you the most
>> flexibility on the client side)?
>>
>> As for "neither work," it appears that at least your wireless is
"working,"
>> but we just can't get the handshake happening. What's with the wired
>> connection? Could you post a snippet from LANTRAN.LOG?
___
Lewis G Rosenthal
Rosenthal a Rosenthal, LLC
Sent with SnapperMail
terug naar list