Blue Thinkvantage button during POST, and then F1 (I believe) to get to BIOS setup. If you have Rescue & Recovery set up, this may be a little more involved. From the manual:
1. To protect yourself against accidental loss of data, back up your
data and
computer registry. For details see the "Data backup-and-restore
tools"
section of Access Help.
2. If the diskette drive is connected to the computer, remove any
diskette
from the diskette drive, and then turn off the computer.
3. Turn on the computer; then, while the message, "To interrupt normal
startup, press the blue ThinkVantage button" is displayed at the
lower left
of the screen, press the ThinkVantage button. The Rescue and Recovery
workspace opens.
4. Click Access BIOS. The System Restart Required window is displayed.
5. Click Yes. The computer restarts, and the BIOS Setup Utility menu
appears.
If you have set a supervisor password, the BIOS Setup Utility menu
appears after you enter the password. You can start the utility
by pressing
Enter instead of entering the supervisor password; however, you
cannot
change the parameters that are protected by the supervisor
password. For
more information, see the on-board help.
Go to Config | Display and check your settings there.
--
Lewis
-------------------------------------------------------------
Lewis G Rosenthal, CNA, CLP, CLE
Rosenthal & Rosenthal, LLC www.2rosenthals.com
Need a managed Wi-Fi hotspot? www.hautspot.com
Secure, stable, operating system www.ecomstation.com
-------------------------------------------------------------