Poštni seznam arhiviranih sporo?il | Nazaj na seznam |
|
---|
I wonder if anyone has some ideas, here...=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
My previous setup was fairly straightforward: Two CONFIGs, one for wired; one for wireless. In each case, the single bound NIC was LAN0. PROTOCOL.INI entries looked like this:
[odi2ndi_nif]
DriverName = odi2ndi$
Bindings = ciscopcm_nif
NETADDRESS = "I000750CA41BF"
TOKEN-RING = "no"
TOKEN-RING_SNAP = "no"
ETHERNET_802.2 = "yes"
ETHERNET_802.3 = "no"
ETHERNET_II = "no"
ETHERNET_SNAP = "no"
TRACE = 0x0
For the wired CONFIG, all entries were identical except for the driver name, binding, and MAC. Everything worked.
Now, I'm using a single CONFIG, enabling both interfaces. PROTOCOL.INI looks like this:
[odi2ndi_nif]
DriverName = odi2ndi$
Bindings = E100BEO2_nif,ciscopcm_nif
NETADDRESS = "I0003476D5C1A","I000750CA41BF"
TOKEN-RING = "no","no"
TOKEN-RING_SNAP = "no","no"
ETHERNET_802.3 = "no","no"
ETHERNET_802.2 = "yes","yes"
ETHERNET_II = "no","no"
ETHERNET_SNAP = "no","no"
TRACE = 0x0
However, only LAN0 seems to be binding IPX (i.e., I can't find the LAN from the Wi-Fi interface, LAN1). Is there something else I should be doing to bind both NICs to IPX? I've had systems with two NICs bound to IPX before, but don't remember anything special. There are no board-specific entries in NET.CFG.
TIA
Naro?iti: Poro?ilo (Feed),
Izvle?ek (Digest),
Indeks. Odjava E-pošta za mojstra za sezname |