I see that you have SSID = "ANY" whereas I have "WLAN" and that you
have DEBUGLEVEL = "NONE" whereas mine says "NO". Is there any
significance to the former difference? The latter I assume is the very
same setting which can be expressed in two different ways.
Hakan
On Sun, 17 Feb 2008 10:26:49 -0500, Lewis G Rosenthal wrote:
>Apologies for the top post, all...just following the flow.
>
>Sorry, I've been reading this thread off and on from my handheld,
>without regard to the threading, and have been missing much of the
>discussion. My apologies, Hakan.
>
>Here's what I have in PROTOCOL.INI:
>
>[W8086X4224_nif]
>
> DriverName = WRND32$
> VENDOR = 0x8086
> DEVICE = 0x4224
> NDIS_SYS = "W29N51.SYS"
> NDIS_INF = "W29N51.INF"
> SSID = "ANY"
> DEBUGLEVEL = "NONE"
> OPTIONS = "NONE"
>
>Note that I am no longer using the STACK32 option (on the OPTIONS =
>line). I believe (now that I think of it) that the requirement for it
>has to do with the version of UNIAUD in use, and the later builds of
>UNIAUD seem to play better (pardon the pun) with GenMAC than they did
>some time ago (there was a time when we couldn't get sound at all with
>GenMAC installed).
>
>So, to answer your point, and Christian's (and apologies if I've led
>everyone astray by talking off the top of my head earlier), STACK32
>is/was necessary for the w29n51.sys driver, which did/will trap under
>older UNIAUD builds without it. However, using the newest builds of
>UNIAUD (1.1.4+), you should be fine, as above.
>
>Hakan, what was your trap, anyway? 008? (That's what I would expect,
>which would indicate an interrupt conflict.)
>
>On 02/15/08 10:03 am, Hakan thus wrote :
>> Hi Lewis,
>>
>> Where should add this statement? Thanks.
>>
>> Hakan
>>
>> On Thu, 14 Feb 2008 22:58:35 -0500, Lewis G Rosenthal wrote:
>>
>>
>>> OPTIONS = STACK32
back to list