I upgraded to 2.14 because of the new bits for switching wired/wireless but it
seems worse than before, maybe 2.10. This is with the generic PRISM driver -
My Artem card is not supported by Genmac.
I always assign a dummy IP to the unused NIC and do that in the xwlan.cmd file
on CONNECT
if WLan._Profilename = "Home" then do
'ifconfig lan0 192.168.200.250';
on DISCONNECT
if WLan._Profilename = "Home" then do
'ifconfig lan1 192.168.201.251';
Otherwise the NICs get addressed via DHCP. What seems to happen now is that,
say going wireless -> wired. The WIFI drops and the IP gets assigned as above
and then nothing. A netstat -r at this point will show only the local loopback,
& lan0 and 1 as above addresses. dhcpmon shows lan1 released.
The only way to get things back is to manually find and kill DHCPD.EXE and then
run setup from x:/MPTN/bin. I have "Run setup" checked in the WIFI profile.
Nazaj na seznam