Mailing List os2-wireless_users@2rosenthals.com Archived Message #2128 | back to list |
|
---|
The Cisco AIR-MP20B should be handled by GenMAC 1.7 (I think), howeever, there is mention of the T30 not supporting this card under certain firmware revs (ThinkPad firmware, not card firmware).<loud buzzer> Incorrect: it may indeed be the firmware on the card and not eh T30 firmware. I haven't checked the firmware rev on the card, but I will indeed (see http://www.thinkwiki.org/wiki/Cisco_Aironet_Wireless_802.11b, which describes a similar issue we've seen with the 350 PCMCIA cards not functioning with later Cisco firmware). I'll follow up in another thread when I get a chance to flash the card to a known-good firmware rev.
GenMAC loaded up the first time without coughing, but subsequent boot cycles brought me up to a TRAP 8 (interrupt left hot?), and the first time around I was not able to get the card to be seen. So...on to option number two.I did indeed get this with *and without* the STACK32 param on the OPTIONS line for the driver in PROTOCOL.INI, before anyone brings this to my attention. I also got it with UNIAUD completely remmed out of CONFIG.SYS (ergo, no audio whatsoever). the only protocol loaded for the card was TCP/IP, and I even went so far as to unload all other protocols (IPX included) for the wired NIC - same result.
Subscribe: Feed,
Digest,
Index. Unsubscribe Mail to ListMaster |