| os2-wireless_users@2rosenthals.com Messaggio archiviato #3241 |
torna alla lista |
|
|---|
Which are working fine indeed.
route -fh
arp -f
ifconfig lo 127.0.0.1
dhcpstrt -i lan0 -d 20
ipgate off
This all fine for your wired interface.
Let's see protocol.ini to make sure it matches up.
It does.IBM OS/2 LANMSGDD [08/01/02] 6.00 is loaded and operational.
SYS0318: Message file AR0.MSG cannot be found for message 0042.
IBM OS/2 LAN Netbind
I suspect AR0.MSG came with the artem driver
. You need to make sure itAs there are no instructies to put it at a specific location I just had put it in \ ibmcom\macs.
can be found in DPATH.
Bought it at Mensys 2 years ago.Artem Onair Comcard 11 5V PCMCIA card.
driver version: ARWLAN$ v1.50
Just wondering. Is this the same card as Mensys supplies?
/V switch doesn't trigger additional information apparently.Config.sys: DEVICE=E:\IBMCOM\MACS\ARLTNDIS.OS2
You might try adding /V in case there's something useful to report.
Apparently it doesn't. But it could well be more a T41 issue than anything else.Yep. Status OK and ready. btw: I had to disable com.sys to free an irq.
Humm. I'm surprised the driver would not share an IRQ.
IRQ3 should be
fine for now.
|
Isriviti: Feed,
Riassunto,
Indice. Disiscriviti Scrivi a ListMaster |