os2-wireless_users@2rosenthals.com ?????????????? ????? #3715

???:	"Stanley Sidlov" <os2-wireless_users@2rosenthals.com>	?? ???? ?????????
???:	os2-wireless_users-owner <os2-wireless_users-owner@2rosenthals.com>
??:	[OS2Wireless] need 'ireless' hub....
??:	Tue, 29 Mar 2005 22:26:20 -0500 (EST)
??:	"os2-wireless_users@2rosenthals.com" <os2-wireless_users@2rosenthals.com>

On Tue, 29 Mar 2005 21:28 -0500, Lewis G Rosenthal wrote: >The LinkSys WRT54G can be put in bridge mode, too. This requires two of >them, & appropriate firmware, but I've done this successfully, while >maintaining 128-bit encryption and over a fairly long range (for a WRT54G). why two? Won't it work with anything else? I have a SMC 2655W AP already. It's a dumb "B" AP device. Does Access control and WEP. I went to CompUSA, and I was going to get a Linksys WET11, but saw that there was a Netgear WG602v3 http://kbserver.netgear.com/products/WG602v3.asp. Since the box had a diagram showing the 602 connected to a hub, with wired devices, and stated that it could be bridged, and had "G" functions, I decided to purchase that. It was the same price as the "B" only WET11. I have the 602 setup to be in Point-to-Point bridge mode. For now, I disabled it's wireless client portion. I turned off Access Control in the 2655W. I set it to the following: 1. I had it generate keys, and I used the same Hex values (cut/paste) on the existing AP. (I've noticed that some devices don't use the same passphrase translation.) 2. I set it to use Open, and Long preamble. 3. I set it to be "B" only. 4. I can 'see' the other AP in the bridge table. I can see the channel, SSID, and signal strength. This is supposed to mean that I have configured the WEP and channels correctly. However, no device appears to get a DHCP response via the unit. Neither wired or wireless (when I reenabled the wireless client support.) I have no clue. Stan Sidlov -- http://www.warpstock.org Warpstock 2004 wasin Denver, Colorado! October 21-24, what WERE YOU doing that weekend? =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= To unsubscribe from this list, send a message to steward@2rosenthals.com with the command "unsubscribe os2-wireless_users" in the body (omit the quotes). For help with other commands, send a message to steward@2rosenthals.com with the command "help" in the body (omit the quotes). This list is hosted by Rosenthal & Rosenthal P.O. Box 281, Deer Park, NY 11729-0281. Non- electronic communications related to content contained in these messages should be directed to the above address. (CAN-SPAM Act of 2003) =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=

???????: ????, ??????, ??????.
?????????
??? ????????