I have a T21 with a built in Intel PRO 100 wired NIC installed and a Cisco 350 PC card.
If I install only one NIC adapter at a time, my file and print sharing works just fine. In this scenario, when I wish to change from one card to the other, I go into Adapters and Protocols and select the adapter I wish to change to, click the Change button, save the settings, and reboot. Each card works properly when its adapter is installed, and my File and Print Sharing also works just fine.
My problem is that when I install both adapters, my File and Print Sharing will not start. Both NICs will work as expected when using scripts to change from one to the other, etc.
At the present time, I have Adapters and Protocols set up as follows:
Intel PRO/100 Network Connection
1 - IBM OS/2 NETBIOS
0 - IBM OS/2 NETBIOS OVER TCP/IP
0 - IBM TCP/IP
Cisco Aironet 340/350 11 Mbps Wireless Adapter
3 - IBM OS/2 NETBIOS
2 - IBM OS/2 NETBIOS OVER TCP/IP
2 - IBM TCP/IP
In the TCP/IP Configuration Notebook, lan0 is enabled using DHCP, and lan1 is disabled.
TIA,
Stu Updike
Bedford, Texas
USA
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
To unsubscribe from this list, send a message to
steward@2rosenthals.com with the command
"unsubscribe os2-wireless_users" in the body
(omit the quotes).
For help with other commands, send a message
to steward@2rosenthals.com with the command
"help" in the body (omit the quotes).
This list is hosted by Rosenthal & Rosenthal
P.O. Box 281, Deer Park, NY 11729-0281. Non-
electronic communications related to content
contained in these messages should be directed
to the above address. (CAN-SPAM Act of 2003)
volver a la lista