** Reply to note from "OS/2 Wireless Users Mailing List" <os2-wireless_users@2rosenthals.com> Fri, 10 Apr 2009 05:07:05 -0400
>
> Although the device you are connected to is a router, what you are actually using is the built in n-way switch. I presume the subnet
> mask in use is 255.255.255.0 ? If so all three addresses are on the same network subnet and you don't need to set any routes on
> the systems, the two PCs should "see" each other. Perhaps if you are executing a route command this is causing the problem ?
>
This is my network start file. Internet out is fine. Ftp is fine as long as server is running. Stop server and restart later, error message
from client: can not find the ip address. Since I always had to reboot when trying ftpserver again, tried resetting the routes by:
route flush and then run setup.cmd. Am not familiar with networks and tcpip to know if this is normal but one would think not. Should
not be the router either as you say it is just a switch.
**setup.cmd**
ifconfig lo 127.0.0.1
ifconfig lan0 192.168.1.100 netmask 255.255.255.0 metric 1 mtu 1492
route add default 192.168.1.1
route add -net 192.168.0.1 192.168.1.1 -netmask 255.255.255.0 -hopcount 1
ipgate off
Also find file below on boot but appears to be for peer network which is not installed.
tcpcoex.log
Log file for TCPCOEX.EXE ..... run time: Fri Apr 10 08:24:44 2009
FINDOURDIRS: nfsctl.exe not found!
TCPDIR(s):D:\TCPIP
END TCPCOEX.EXE
Main question on this is: is it normal to have to run setup.cmd to re-establish the route through router?
Cal
--
This email was Anti Virus checked by Astaro Security Gateway. http://www.astaro.com
back to list