Mailing List os2-wireless_users@2rosenthals.com Archived Message #586

back to list

I'm trying to get the Wireless to work on my T43 (2686-DJU). I have
the lan port active using the Broadcom 1 Gig Driver, but when I try
and get the GenMac drivers to work 2915/A/B/G, they do not load. I
can get the Intel 2200 Drivers to load via GenMac, but WLan reports
no driver loaded and the LanTran.log shows

WRND32$ Wrapper for bus: 4 slot: 2 Vendor x8086 Device: 0x4220
WRND32$ load Sys: "W29N50A.SYS" Error !
WRND32$ Wrapper Init ERROR !

Now GenMac show 2 2915 drives available. I have tried both and get
the following results:

During Boot I get a message

NO VALID HARDWARE FOUND FOR (WRND32$)

The PCI program reports that I have a PRO/Wireless 2200BG Network
Connection

I zapped the bios back to 1.24 as referenced by Lewis in an earlier
post.

Please note that is all with eCS V2.0 Beta 3.

Cheers,





Eric Erickson
Elvish Software Foundry, Inc. - Internet: drowelf@vnet.net
Already where I want to be Today - Voice/Fax: (218)-398-2625


=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
This message is sent to you because you are subscribed to
the mailing list .
To unsubscribe, E-mail to:
To switch to the DIGEST mode, E-mail to
To switch to the INDEX mode, E-mail to
Send administrative queries to
To subscribe (new addresses), E-mail to: and reply to the confirmation email.

This list is hosted by Rosenthal & Rosenthal
P.O. Box 281, Deer Park, NY 11729-0281. Non-
electronic communications related to content
contained in these messages should be directed
to the above address. (CAN-SPAM Act of 2003)

=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=