When the D-Link is used in Client Mode as a wireless card and is changed from static IP to dynamic IP addressing, it immediately changes its IP address. As a result, I am not able to communicate with its html based control panel. Is there a command I can issue to get a listing of all the devices and/or the IPs attached to my computer?
Also, I would like to create two CMD files: one that would change from static IP to dynamic IP addressing and one that would change from dynamic IP to static IP addressing and assign a specific address.
If it would not be too much trouble, could someone please show me how those files should look?
TIA,
Stu Updike
Bedford, Texas
--
This email was Anti Virus checked by Astaro Security Gateway. http://www.astaro.com
?????