Mailing List os2-wireless_users@2rosenthals.com Archived Message #6270 | ![]() ![]() |
|
---|
Lewis G Rosenthal wrote:Yes, to flash with mini first, just to get the factory firmware cleared out, then flash again with std to get the full image into the device.
The "Peacock" thread (not announcement) is here:I'll look at that later today.
I think my statement missed a word in the first sentence, which should have read, "This refers to the latest firmware revision." I might have been over-generalizing, though, as that thread is quite good all around. AFAIK, 2.3 SP2 should work fine (at least standard; I don't recall whether I've ever done it under mini).
The instructions I followed said install mini first and then std.
:-)You mistake me for someone who knows what he is doing. Up to this point a router was something I just plugged in and ignored, except for watching the lights. When I got a wireless laptop and router I eventually turned on security. DHCP was just something I selected when installing an OS. I have encountered references to DHCP in at least a couple places in these routers, but have avoided altering what I did not understand.Please give me some details as to IP addresses in each router, whether DHCP service is enabled on each one (should be *only* on the GS, unless you are getting DHCP from somewhere else or using static IP), and what your default gateway is on a connected client (should be the IP address of your GS).
Subscribe: Feed,
Digest,
Index. Unsubscribe Mail to ListMaster |