Mailing List os2-wireless_users@2rosenthals.com Archived Message #6547

From:	"Lewis G Rosenthal" <os2-wireless_users@2rosenthals.com>	Full Headers Undecoded message
Subject:	Re: [OS2Wireless] eCS install of a new NIC
Date:	Wed, 10 Feb 2010 16:48:27 -0500
To:	OS/2 Wireless Users Mailing List <os2-wireless_users@2rosenthals.com>

Hi, Jordan. Apologies for the late follow-up... On 02/04/10 10:53 am, J R FOX thus wrote : The Genmac autodetect has worked for me, on the couple occasions when I installed one of the RC_ releases. But those were on fresh, complete installs of eCS. How might this be redone -- for a different NIC -- for an existing setup, rather than having to do a complete new install from scratch ? Please go into detail. If you have eCS 2.0 RC 7 media: 1. Go to x:\CID\SERVER\ECSPKG (where x: is the drive letter of your CD drive) and run GENMAC2.WPI. 2. The installer will autodetect any supported cards and will install the drivers for them. 3. Open MPTS, and you should be able to select your newly installed network card from the list. Bind it as you normally would, *after* removing the "old" card from the configuration, if present. If you do not have the eCS 2.0 installation media: 1. Go to http://genmac.netlabs.org/en/site/downloads.xml and download the full installer (unless you know which card is in the system). 2. Run the WPI file, and then follow steps 2-3, above. HTH -- Lewis ------------------------------------------------------------- Lewis G Rosenthal, CNA, CLP, CLE Rosenthal & Rosenthal, LLC www.2rosenthals.com Need a managed Wi-Fi hotspot? www.hautspot.com visit my IT blog www.2rosenthals.net/wordpress -------------------------------------------------------------

Subscribe: Feed, Digest, Index.
Unsubscribe
Mail to ListMaster