os2-wireless_users@2rosenthals.com Messaggio archiviato #6547 messaggio precedente messaggio successivo torna alla lista

Da: "Lewis G Rosenthal" <os2-wireless_users@2rosenthals.com> Intestazioni complete
Messaggio non codificato
Oggetto: Re: [OS2Wireless] eCS install of a new NIC
Data: Wed, 10 Feb 2010 16:48:27 -0500
A: OS/2 Wireless Users Mailing List <os2-wireless_users@2rosenthals.com>

Hi, Jordan. Apologies for the late follow-up...

On 02/04/10 10:53 am, J R FOX thus wrote :
The Genmac autodetect has worked for me, on the couple occasions when I installed one of the RC_ releases.  But those were on fresh, complete installs of eCS.  How might this be redone -- for a different NIC -- for an existing setup, rather than having to do a complete new install from scratch ?  Please go into detail.

  
If you have eCS 2.0 RC 7 media:

  1. Go to x:\CID\SERVER\ECSPKG (where x: is the drive letter of your
     CD drive) and run GENMAC2.WPI.
  2. The installer will autodetect any supported cards and will install
     the drivers for them.
  3. Open MPTS, and you should be able to select your newly installed
     network card from the list. Bind it as you normally would, *after*
     removing the "old" card from the configuration, if present.

If you do not have the eCS 2.0 installation media:

  1. Go to http://genmac.netlabs.org/en/site/downloads.xml and download
     the full installer (unless you know which card is in the system).
  2. Run the WPI file, and then follow steps 2-3, above.

HTH

--
Lewis
-------------------------------------------------------------
Lewis G Rosenthal, CNA, CLP, CLE
Rosenthal & Rosenthal, LLC                www.2rosenthals.com
Need a managed Wi-Fi hotspot?                www.hautspot.com
visit my IT blog                www.2rosenthals.net/wordpress
-------------------------------------------------------------
Isriviti: Feed, Riassunto, Indice.
Disiscriviti
Scrivi a ListMaster