Poštni seznam arhiviranih sporo?il | Nazaj na seznam |
|
---|
On Sun, 25 Feb 2007 18:52:16 +0100 (CET), Jan van Wijk wrote:Make sure HELPERW.exe is the VERY FIRST line in Config.sys.
Hi Eric,
On Sun, 25 Feb 2007 11:33:51 -0600 (CST), Eric A. Erickson wrote:
I had to rebuild my T43 and now after installing eCS Beta 3 I get theKnown problem, I had the same, you are most likely missing
following error during boot. No valid hardware info in protocol.ini for ("WRNDS32$ ")
the VENDOR and DEVICE lines missing, see below for what
it should look like (Intel 2200 on a T42p)
++++
[W8086X4220_NIF]
DriverName = WRND32$
VENDOR = 0x8086
DEVICE = 0x4220
NDIS_SYS = "W29N50.SYS"
NDIS_INF = "w8086x4220.inf"
SSID = "w34rfvbhu89ol"
DEBUGLEVEL = "NONE"
OPTIONS = "NONE"
++++
Regards, JvW
Jens, Actually it turned out to be something totally different. I did not
have the Wired (Broadcom) NIC defined in MPTS yet. When I added the
IBM TP43 Broadcom NIC Driver, it now loads. My next problem is that xWLan 3.0 does not show the device as
available. When I click on the device tab nothing is shown. There are
no strange error messages in the LanTran.log and I'm still running
the 1.24 Bios on my TP 43. I had this working once, before the re-build, but I'm clueless at the
moment as to what to try next. Eric Erickson
Elvish Software Foundry, Inc. - Internet: drowelf@vnet.net
Already where I want to be Today - Voice/Fax: (218)-398-2625
Naro?iti: Poro?ilo (Feed),
Izvle?ek (Digest),
Indeks. Odjava E-pošta za mojstra za sezname |