In <list-940321@2rosenthals.com>, on 02/28/07
at 08:30 PM, "Lewis G Rosenthal" <os2-wireless_users@2rosenthals.com>
typed: >GenMAC loads up fine and recognizes the card (I double-checked
with >pci.exe, as these cards are actually Access Point cards -
AIR-MP20B-A). >Upon reaching the desktop, everything goes fine until
xCenter loads, and >then a nasty TRAP008 hits (hot interrupt). So, I
figured that the >problem may be with UNIAUD (I was using the build which
ships with eCS >1.2R, dated 8/2005). I updated UNIAUD, but no dice. In
fact, at odd >intervals, the other MMPM modules fail to load (perhaps the
interrupt >conflict followed by the TRAP008 leaves either the audio or
the Cisco >card in a hung state upon warm reset).
>So, I'm going to roll back and wait for the Intel cards to show up. Is
>anyone else using a Cisco mPCI with GenMAC, XWLAN, and UNIAUD?
Just for laffs, what happens if you disable sound and MM entirely on the
machine?
--
Julian Thomas: jt@jt-mj.net http://jt-mj.net
In the beautiful Finger Lakes Wine Country of New York State!
-- --
A truly wise man never plays leapfrog with a unicorn.
torna alla lista