OK, thanks.  That would be in addition to MPTCONFG.INI mentioned in my
posting.

On Sun, 17 Feb 2008 09:51:36 +1100, Ed Durrant wrote:

  

Protocol.ini and to a lesser extent TCPOS2.INI and IBMLAN.INI depending upon what you have changed.

If I get strange errors at boot up, I find re-running through LANINST in \IBMLAN\Install will often pull the various configuration files back into line with each other.

Cheers/2

Ed.

Hakan wrote:
    

Also, which files are modified when I change settings in MPTS?
MPTCONFG.INI, PROTOCOL.INI and perhaps some other files?

On Fri, 15 Feb 2008 10:03:37 -0500 (EST), Hakan wrote:

  
      

Hi Lewis,

Where should add this statement?  Thanks.

Hakan

On Thu, 14 Feb 2008 22:58:35 -0500, Lewis G Rosenthal wrote:

            

OPTIONS = STACK32

...... Original Message .......
On Thu, 14 Feb 2008 20:49:31 -0500 (EST) "Hakan" <os2-wireless_users@2rosenthals.com> wrote:
                

I have had Genmac for the Intel 2915 working under eCS 1.2MR on my
TP43P before but decided to reinstall the OS.  Apparently there is some
configuration issue I have forgotten because after installing Genmac
and the appropriate driver, the system traps when booting.  BTW, this
is Genmac 2.00 from the netlabs.org site.

Has anyone seen this before and what might the fix be?  Again, I have
had it working at an earlier time...




            

<os2-wireless_users-digest@2rosenthals.com>
                

To switch to the INDEX mode, E-mail to                    

<os2-wireless_users-index@2rosenthals.com>
                

Send administrative queries to                      

<os2-wireless_users-request@2rosenthals.com>
                

To subscribe (new addresses), E-mail to:                    

<os2-wireless_users-on@2rosenthals.com> and reply to the confirmation email.
                

            

___
Lewis G Rosenthal
Rosenthal & Rosenthal, LLC
Sent with SnapperMail